MaintenanceTOC
Table of Contents
RT-flex50DF
2016
2/ 4 Winterthur Gas & Diesel Ltd.
Engine Stays with Friction Shims: Tension − Checks 1715−1/A1......................................
Hydraulic Engine Stays: Oil Pressure Checks 1715−1/A2.............................................
Tie Rod: Tension Checks and Replacement Procedure 1903−1/A1.....................................
Cylinder Liner and Cylinder Cover Group 2
Cylinder Liner
Measure the Cylinder Liner 2124−1/A1...........................................................
Removal and Installation 2124−2/A1.............................................................
Remove Unwanted Material, Dress the Lubricating Grooves and Scavenge Ports 2124−3/A1............
Lubricating Quill: Removal and Installation 2138−1/A1...............................................
Gas Admission Valve GAV50: Removal, Disassemble, Checks, Assemble, Installation 2140−1/A1.......
Piston Rod Gland: Removal, Disassemble, Measure Worn Parts, Assemble, Installation 2303−1/A1......
Cylinder Cover
Cylinder Cover and Water Guide Jacket − Removal and Installation 2708−1/A1........................
Cylinder Cover Elastic Studs − Loosen and Apply Tension 2708−2/A1................................
Machining of Sealing Face for Injection Valve 2708−3/A1............................................
Sealing Face for the Pilot Injection Valve Position − Grind 2708−4/A1................................
Sealing Face for the Fuel Injection Valve Position − Grind 2708−5/A1................................
Sealing Face for the Prechamber − Grind 2708−6/A1..............................................
Injection Valve: Removal and Installation 2722−1/A1.................................................
Injection Valve: Checks, Disassemble, Assemble 2722−2/A1.........................................
Injection Valve: Installation of Injection Valve with FAST 2722−1/A2...................................
Starting Air Valve: Removal, Disassemble, Grind, Assemble, Installation 2728−1/A1....................
Exhaust Valve
Removal and Installation of Exhaust Valve, Replacement of Elastic Studs 2751−1/A1...................
Disassemble and Assemble 2751−
2/A1...........................................................
Replacing and Grinding the Valve Seat 2751−3/A1.................................................
Grinding the Seating Surface on the Valve Head 2751−4/A1.........................................
Pilot Injection Valve: Removal, Disassemble, Check, Assemble, Installation 2790−1/A1.................
Crankshaft, Connecting Rod and Piston Group 3
Crankshaft: Crank Deflection − Measure 3103−1/A1.................................................
Vibration Damper
Inspection (GEISLINGER Vibration Damper) 3130−1/A1............................................
Axial Damper: Disassemble and Assemble 3140−1/A1................................................
Turning Gear: Teeth and Screwed Connections Check 3206−1/A1.....................................
Crankcase: Work Platform 3301−1/A1..............................................................
Top Platform: Configuration of Lifting Tools 3301−2/A2...............................................
Winterthur Gas & Diesel Ltd.RT−flex50DF / MM / 2020
To Next Page