WinGD RT-flex50DF - Page 161

Maintenance
2303−1/A1
Winterthur Gas & Diesel Ltd.
1/ 6
Removal, Disassemble, Measure Worn Parts, Assemble,
Installation
Tools:
2 Distance holders 94345 2 Distance pieces 94345F−9
1 Clamp ring (2-part) 94345B 2 Distance pieces 94345F−11
1 Gauge 94345C 2 Distance pieces 94345F−13
2 Spring assembly tools 94345E 2 Work supports 94143
2 Work platforms 94142
1. General 1..........................................................
2. Preparation 1.......................................................
3. Removal 2.........................................................
4. Disassemble 3.....................................................
5. Worn Parts − Measure 3.............................................
6. Assemble 5........................................................
7. Installation 6.......................................................
1. General
WARNING
Injury Hazard: Before you operate the turning gear, make sure that
no personnel are near the flywheel, or in the engine.
CAUTION
Damage Hazard: Each time you operate the turning gear, you must
remove the platform (94142). This will prevent damage to
equipment. After you use the turning gear, you can install the
platform (94142) again.
The removal of the piston rod gland is done at the same time as the piston removal.
Examine the piston rod gland for wear and damage during each overhaul of the
piston (refer to 0380−1, Piston rod gland). If necessary, replace the unserviceable
parts.
When you assemble the piston rod gland, make sure that all parts are in a serviceable
condition.
2. Preparation
1) Remove the piston together with the piston rod gland, refer to 3403−1 Piston −
Removal and Installation.
2) Install the work platforms (94142) and the work supports (94143). Make sure that the
grids and work supports are correctly attached.
2016
Piston Rod Gland