wsm M8540NARROW - Page 50

GENERAL
M8540Narrow, M9540Narrow, WSM
NG-28
Draining Fuel Tank Water
1. Loosen the drain plugs (2) at the bottom of the fuel tank (1) to
let sediments, impurities and water out of the tank. Finally
tighten up the plugs.
IMPORTANT
• If the fuel contains poor qualities with much water in it,
drain the fuel tank at shorter intervals.
• Drain the fuel tank before operating the tractor after a long
period of storage.
• The fuel tank is made of plastic. Be careful not to
overtighten the bolts.
9Y1210236GEG0030US0
Cleaning Inner Air Filter (CABIN Model)
1. Remove the inner filter, and blow air from the direction opposite
to the filter's normal air flow.
2. Pressure of compressed air must be under 205 kPa
(2.1 kgf/cm
2
, 30 psi).
(Reference)
• Detach and attach the push-rivet (2) as follows.
– Detaching procedure
Push in the center rivet "a" and pull out the push-rivet
assembly "b".
– Attaching procedure
Pull out the center rivet "c", attach the push-rivet assembly
"d" and push up the center-rivet "e".
9Y1210236GEG0031US0
(1) Fuel Tank
(2) Drain Plug
[A] ROPS Model
[B] CABIN Model
(1) Inner Air Filter
(2) Push-rivet
(3) Center-rivet
a: Push in center-rivet
b: Pull out push-rivet assembly
c: Pull out center-rivet
d: Attach push-rivet assembly
e: Push up center-rivet
KiSC issued 07, 2013 A