Xerox 8850 - Page 188

03/2003
4-112
8850/ 510DP
REP 10.1
Repairs and Adjustments
3. (Figure 3): Disconnect the Heat Rods and guide them into the Fuser Heat Roll (Right
Side).
Figure 3 Guiding the Heat Rods into the Fuser Heat Roll (Right Side)
CAUTION
Wear gloves or wrap a sheet of paper around the Heat Rod when handling the Heat Rod. Do
not touch the glass section of the Heat Rod. Oil from fingers can cause damage to the Heat
Rod.
4. (Figure 4): Remove the Heat Rod(s).
NOTE: The heat rods can be removed from either side of the Fuser Module.
Figure 4 Removing the HeatRod(s)
1
Disconnect the two Heat
Rod connectors
2
Remove the two wires
from the wire clamp
4
Carefully remove the two Heat
Rods from the rubber grom-
met
3
Remove the Heat Rod Support
Bracket (2 screws)
1
Remove the Heat Rod(s)