03/2003
6-28
8850/ 510DP
Installation Procedure
General Procedures
17. (Figure 13): Reinstall the sump shield, dispenser end first.
Figure 13 Reinstalling the sump shield
18. (Figure 14): Disengage the Developer drive.
Figure 14 Disengaging the Developer Drive
1
Position the sump shield in
the sump by rotating it
around the plunger
2
Reinstall the edges of the shield
under the edge on the housing
1
Slide Gear Locking Retainer
away from the gear and latch
into the unlock position
To Next Page
Loading...
