Xerox 8850 - Page 315

03/2003
6-29
8850/ 510DP
Installation Procedure
General Procedures
19. (Figure 15): Reinstall the toner cartridge.
Figure 15 Reinstalling the toner cartridge
20. (Figure 16): Complete the toner cartridge installation.
Figure 16 Completing the toner cartridge installation
21. Close the developer module cover.
22. Raise and hold the top cover while reinstalling the rear developer cover.
1
Insert the front end of the toner cartridge into the
developer module.
2
Pull the cartridge
hub back and
guide the rear
end of the car-
tridge into place.
3
Rock the toner cartridge
back and forth to ensure
correct engagement of car-
tridge to motor.
2
Close the cover.
1
Remove the tape.