Media Types
ColorQube™ 9301/9302/9303
Paper and Media
247
Media Types
This section describes the different types of media which can be loaded in your device. For further
information about media types and specifications, refer to www.xerox.com.
The Type can be selected from a drop-down menu for the adjustable trays. It is important to select the
correct Type setting for the media loaded in each tray. The device can detect different types of media
as it travels through the paper path and will halt a job if a mismatch occurs.
The following media types are supported:
•Plain
•Pre-punched
• Transparency
•Pre-Printed
•Recycled Paper
•Labels
• Heavyweight
• Extra Heavyweight
•Pre-Cut Tabs
•Envelopes
Plain
This media type is used for plain and colored paper, as well as lightweight card. It is also the option
used when loading carbonless paper.
The following paper types are not recommended:
•Coated papers
•Conductive papers
• Papers containing talc
• Highly glossy paper
• Papers containing wax, stearate or plasticiser
Pre-Punched
This media type is used for hole punched media which has two or more holes along one edge for use in
ring binders and notebooks. To ensure ink is not placed where the holes occur, a small deletion is
applied to the binding edge of the image.
• Load pre-punched paper with the holes on the right edge in Trays 1, 2, 3 and Tray 6 (Inserter).
To Next Page
Loading...
