Media Types
ColorQube™ 9301/9302/9303
Paper and Media
248
• Load pre-punched paper with the holes on the left edge in Tray 4 (Bypass) and Tray 5.
Note If the deletion will affect the output image, refer to the Copy guide for instructions on using
Image Shift.
CAUTION: Before loading the media make sure that any plugs (the round pieces cut out of the
paper to create the holes) do not remain in the stack. If they get into the system they can cause
jams and can also damage the internal components of the device. Fan the media to help separate
the individual sheets.
Transparencies
Transparencies are used to create images that can be projected on to a screen for presentations, or as
covers. Transparencies are made of polyester film coated with a chemical substance. Clear
transparencies allow maximum presentation space.
Note Only Tray 4 (Bypass) can be
used to feed transparencies.
• Load transparencies which have a
white strip along one edge with the
strip to the left and on the underside
of the transparencies.
• Fan transparencies to stop them
sticking together.
• Load transparencies on top of a small
stack of same-size paper.
If a coating of oil remains on the transparency after printing, remove it with a lint free cloth.
Pre-Printed
Use this option for pre-printed paper such as letterheads and forms.
• Load pre-printed paper face up and with the top towards the front of the device in Trays 1, 2, 3
and Tray 6 (Inserter).
• Load pre-printed paper face down and with the top towards the front of the device in Tray 4
(Bypass) and Tray 5.
Recycled Paper
Use this option for any Recycled paper being loaded in the trays.
The device supports recycled media that has been designed for laser and solid ink devices, such as
Xerox Recycled paper.
To Next Page
Loading...
