Xerox ColorQube 9303 - Labels; Heavyweight and Extra Heavyweight; Pre-Cut Tabs

Media Types
ColorQube™ 9301/9302/9303
Paper and Media
249
Labels
Labels consist of three layers, the face
sheet, pressure sensitive adhesive and the
backing or release sheet. The device
supports labels that have been designed
for laser and solid ink devices, such as
Xerox Labels. The adhesives are designed
to withstand the higher temperatures of
these devices without bleeding and
causing spotting or damage to the internal
components.
Note Dry gum labels (those that
require moistening before being applied) can cause dry particles of glue to detach from the
backing and should not be used.
The labels should be left in the printing environment overnight before using it in the printer to allow it
to adjust to the ambient temperature.
• Load labels face up and with the top towards the front of the device in Trays 1 and 2.
• Load labels face down and with the top towards the front of the device in Tray 4 (Bypass).
Note Do not fan the label sheets before use unless the package instructs you to do so. If jamming
or multi-sheet feeding occurs shuffle the labels before loading.
Heavyweight and Extra Heavyweight
Use this paper type for feeding heavyweight and card. The maximum weight which can be fed is
216 gsm (56 lb).
Pre-Cut Tabs
Tabs are used as dividers in documents. Your device can accommodate tabs with 1 to 10 tabs and
weights of up to 200 gsm (53 lb).
• Do not use tabs with bent corners.
They can cause feeding related
problems. If a tab is bent, remove it
from the set and replace it with an
undamaged tab in the same position.
• Tabs can only be loaded into Tray 4
(Bypass).
• The tabs must be loaded with the tab
1 on the top, with the tab to the left.
•Use the Special Pages, Inserts option
in Copy or the Printer Driver to
program inserts where the tabs are required. Refer to the Copy or Print guide for information.