Tray 6 (Inserter)
ColorQube™ 9301/9302/9303
Paper and Media
245
Tray 6 (Inserter)
Tray 6 (Inserter) is an optional paper tray for use with the High Volume Finisher and is used for
inserting post process sheets in the set. This tray provides a very convenient and efficient way of
adding pre-printed covers or inserts to a job. The following media can be loaded in Tray 6 (Inserter):
• Up to 250 sheets of 75 gsm or 20 lb paper.
• Weights from 60 to 216 gsm (16 to 56 lb).
• Media sizes:
• A4 or 8.5x11” SEF or LEF
•8.5x13” SEF
•8.5x14” SEF
• A3 or 11x17” SEF
•Media types:
• Bond, standard or recycled paper
•Card
•Pre-printed media
• Hole punched paper
• Clear transparencies
Tray 6 (Inserter) must not be used to feed labels, envelopes, tabs or carbonless paper. Tray 4 (Bypass)
can be used for these media types.
Loading Tray 6 (Inserter)
A4 or 8.5x11” media may be loaded either long edge feed or short edge feed. Media sizes larger than
A4 or 8.5x11” must be loaded short edge feed.
1. Place the media in the correct orientation for the job.
The labels on the top of Tray 6
(Inserter) provide instructions for
input and output orientations. Refer
to Orientation of Pre-printed Media
on page 246.
2. The paper is registered centrally, to
the left edge of the tray.
Paper must not be loaded above the
maximum fill line.
3. Make sure that the guides just touch
the paper.
To Next Page
Loading...
