Scan to USB
ColorQube™ 9301/9302/9303
USB Port
213
Scan to USB
You can insert a USB Flash Drive into the device, scan a document, and store the scanned file on the
USB Flash Drive.
Note The system administrator must set up this feature before you can use it. Refer to the System
Administrator Guide for instructions.
To scan to a USB Flash Drive:
1. Load the original documents in the document feeder or on the document glass.
2. Insert your USB Flash Drive into the USB port located on the left side of the device.
The USB Drive Detected screen appears.
3. Select Scan to USB.
The Workflow Scanning options are
displayed and the USB Store template
is selected.
4. If required, modify the template
settings using the options on the
Workflow Scanning, Advanced
Settings, Layout Adjustment and
Filing Options tabs.
For information about all the
Workflow Scanning options, refer to
Workflow Scanning Options on page 150.
5. Press Start to scan the originals.
Remove the originals from the document feeder or document glass when scanning has completed.
The file is stored on your USB Flash Drive in the root directory.
6. Remove your USB Flash Drive from the USB port.
To Next Page
Loading...
