4-28 WorkCentre C2424 Service Manual
Tray 3 Pick
2 Unused MFG
Only
3 Tray 3 Pick Interval
(us)
MFG
Only
Reports the interval from the time the engine
software is commanded to start the tray 3 pick
process until the Tray 3 Pick sensor activates.
4 Tray 3 Transport
Interval (us)
MFG
Only
Reports the interval from the Tray 3 Pick
sensor activation until the Deskew sensor
activates.
Tray 2 Pick
2 Unused MFG
Only
3 Unused MFG
Only
4 Tray 2 Pick Interval
(us)
MFG
Only
Reports the interval from the time the engine
software is commanded to start the Tray 2 pick
process until the Deskew sensor activates.
Tray 1 Pick
2 Unused MFG
Only
3 Unused MFG
Only
4 Tray 1 Interval (us) MFG
Only
Reports the interval from the time the engine
software is commanded to start the Tray 1 pick
process until the Deskew sensor activates.
Common
5 Stage Interval (us) MFG
Only
Reports the interval from the time the engine
software is commanded to start the stage
process until the Preheat sensor activates.
(part way through the stage paper motion).
6 Transfix Interval (us) MFG
Only
Reports the interval from the time the engine
software is commanded to start the transfix
process until the Strip sensor activates. (part
way through the paper transfix motion).
Paper Lead Edge Times (Continued)
Paper is picked and moved through either simplex or duplex paper path to determine leading
edge arrival time at each paper path sensor. R values have alternate definitions or are unused
depending on the pick tray and if simplex or duplex path was selected.
R# Definition
Typical
Value Actions
To Next Page
Loading...
Need help?
General