Service Parts Disassembly 8-33
13. The transfix load module fits tightly in the chassis. Rotate the bottom inwards
and pull it forward to remove it from the frame.
Replacement Notes:
Note
Place a small amount of Rheolube 768 grease (P/N 00679900) in the groove
on the end of each transfix load arm before reattaching the spring hooks.
Note
After installing the EMA, perform the Wiper Alignment on (page 6-2). The
printer may report error code 7,009.4x if the wiper assembly is misaligned.
Note
When replacing grounding springs on the transfix load module, make sure
the springs rest below the camshaft assembly.
s2424-1
To Next Page
Loading...
Need help?
General