3-9
INSP
ADJ
E
PERIODIC SERVICE
D30000-0
PERIODIC SERVICE
MAINTENANCE SCHEDULE
The following chart may be taken as a helpful guide to the intervals between maintenance
procedures.
Intervals
Item
Initial Every
Refer page
10 hours
(Break-in)
50 hours
(3 months)
100 hours
(6 months)
200 hours
(1 year)
Anode 3-9
Battery
(every month)
3-10
Carburetor 3-12
Fuel enrichment valve 3-13
Carburetor link 3-13
Cylinder head bolts,
engine mounting bolts,
and flywheel nut
3-11
Fuel filter 3-11
Fuel line 3-11
Gear oil 3-11
Idle-speed 3-15
Ignition timing 3-13
Neutral opening control 3-20
Oil injection pump 3-11
Oil level warning system 3-17
Oil pump link 3-16
Propeller 3-17
Spark plug 3-18
Start-in gear protection 3-19
Throttle cable 3-19
D31000-0
ANODE
Inspect the anode. If it is worn out, replace
it with a new one. If scaling of the surface is
evident, remove the anode and clean it with
a wire brush, and remove all trace of oil or
grease. After cleaning, polish the contact
surfaces of the anode mount, and re-install.
CAUTION:
Never paint the anode. To ensure good
electrical contact, keep the anode contact
surface clean of oil or grease.
To Next Page
Loading...
