Yamaha 30D - ASSEMBLY AND ADJUSTMENT; ASSEMBLY; Propeller-shaft housing

6-10
E
LOWR
ASSEMBLY AND ADJUSTMENT
161009-0
ASSEMBLY AND ADJUSTMENT
ASSEMBLY
Forward gear shim selection
Refer to page 6-15. (For USA and CANADA)
Refer to page 6-18.
(Except for USA and CANADA)
Pinion gear shim selection
Refer to page 6-13. (For USA and CANADA)
Refer to page 6-19.
(Except for USA and CANADA)
Propeller-shaft housing
1. Install the thrust washer and press-fit a
ball-bearing to the reverse gear.
Forward and reverse gear bearing
installer:
YB-6270-A
2. Install a needle bearing with setting the
stamped mark towards upper side.
Needle bearing attachment:
YB-6082/90890-06615
Drive rod:
YB-6229/90890-06604
Bearing depth plate:
90890-06603
Åı
3. Install the oil seals, and then press-fit
the reverse gear complete into the bear-
ing housing.
Oil seal installer:
YB-6168/90890-06634
Drive rod:
YB-6071/90890-06605