YASKAWA GA800

Troubleshooting
7
7.3 List of Fault, Minor Fault, Alarm, and Error Codes
YASKAWA SIEPC71061737D GA800 Drive Technical Reference 357
Display (Hex.) Name ALM LED Type Ref.
oPE03 Multi-Function Input Setting Err Flashing Parameter Setting Error 401
oPE05 Run Cmd/Freq Ref Source Sel Err Flashing Parameter Setting Error 402
oPE06 Control Method Selection Error Flashing Parameter Setting Error 403
oPE07 Analog Input Selection Error Flashing Parameter Setting Error 403
oPE08 Parameter Selection Error Flashing Parameter Setting Error 403
oPE09 PID Control Selection Fault Flashing Parameter Setting Error 404
oPE10 V/f Data Setting Error Flashing Parameter Setting Error 404
oPE11 Carrier Frequency Setting Error Flashing Parameter Setting Error 405
oPE13 Pulse Monitor Selection Error Flashing Parameter Setting Error 405
oPE15 Torque Control Setting Error Flashing Parameter Setting Error 405
oPE16 Energy Saving Constants Error Flashing Parameter Setting Error 405
oPE18 Online Tuning Param Setting Err Flashing Parameter Setting Error 405
oPE20 PG-F3 Setting Error Flashing Parameter Setting Error 405
oPE33 Digital Output Selection Error Flashing Parameter Setting Error 406
oPr (001E) Keypad Connection Fault Illuminated Fault 384
oS (0010) Overspeed Flashing Alarm 397
oS (0018) Overspeed Illuminated Fault 384
ov (0002) Overvoltage Flashing Alarm 398
ov (0008) Overvoltage Illuminated Fault 384
ovEr Too Many Parameters Changed - Not an alarm. 398
PASS Modbus Communication Test Flashing Not an alarm. 398
PE1 (0047) PLC Fault 1 Illuminated Fault 385
PE2 (0048) PLC Fault 2 Illuminated Fault 385
PF (0047) Input Phase Loss Flashing Alarm 398
PF (001B) Input Phase Loss Illuminated Fault 385
PGo (0012) Encoder (PG) Feedback Loss Flashing Alarm 399
PGo (001A) Encoder (PG) Feedback Loss Illuminated Fault 385
PGoH (002B) Encoder (PG) Hardware Fault Flashing Alarm 399
PGoH (0038) Encoder (PG) Hardware Fault Illuminated Fault 386
PWEr DWEZ Password Mismatch - Backup Function Runtime Error 412
rdEr Error Reading Data - Backup Function Runtime Error 412
rF (004E) Braking Resistor Fault Illuminated Fault 386
rH (0010) Braking Resistor Overheat Illuminated Fault 386
rr (000F) Dynamic Braking Transistor Fault Illuminated Fault 386
rUn (001B) Motor Switch during Run Flashing Alarm 399
SC (0005) Short Circuit/ IGBT Failure Illuminated Fault 386
SCF (040F) Safety Circuit Fault Illuminated Fault 387
SE (0020) Modbus Test Mode Error Flashing Alarm 399
SEr (003B) Speed Search Retries Exceeded Illuminated Fault 387
STo (003C) Safe Torque OFF - Alarm 399
SToF (003B) Safe Torque OFF Flashing Alarm 399
STPo (0037) Motor Step-Out Detected Illuminated Fault 387
SvE (0026) Zero Servo Fault Illuminated Fault 387