2.8 Removing/Reattaching Covers
56 YASKAWA SIEPC71061737D GA800 Drive Technical Reference
2. Pull the terminal cover away from the drive.
Figure 2.31 Remove the Terminal Cover
■ Reattach the Terminal Cover
Wire the drive and other peripheral devices then reattach the terminal cover.
Note:
• Wire the grounding terminals first, main circuit terminals next, and control circuit terminals last.
• Make sure that you do not pinch wires or signal lines between the wiring cover and the drive before you reattach the cover.
• Tighten the screws to a tightening torque of 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in).
Figure 2.32 Reattach the Terminal Cover
To Next Page
