3.2 Electrical Installation
70 YASKAWA SIEPC71061737D GA800 Drive Technical Reference
■ Standard Drive Connection Diagram
Figure 3.1 Standard Drive Connection Diagram
*1 Set the wiring sequence to de-energize the drive with the fault relay output. If the drive outputs a fault during fault restart when you use
the fault restart function, set L5-02 = 1 [Fault Contact at Restart Select = Always Active] to de-energize the drive. Be careful when you
use a cut-off sequence. The default setting for L5-02 is 0 [Active Only when Not Restarting].
To Next Page
Loading...
