Setting Up Your System
101
3. Enter the external IP address in the IP Address field.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
5. Click OK to reboot the phone.
To configure ICE feature via web user interface:
1. Click on Network->NAT.
2. In the ICE block, select the desired value from the pull-down list of Active.
3. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
4. Click OK to reboot the phone.
To configure NAT traversal for account via web user interface:
1. Click on Account->Register.
2. Select the desired account from the pull-down list of Account.
To Next Page
Loading...
