Yealink SIP-T2 Series User Manual

Configuring Basic Features
537
Reboot in Talking
Reboot in talking feature allows IP phones to reboot during an active call when it receives a
reboot request by action URI. For more information on action URI, refer to Action URI on page
693.
IP phones do not receive and handle HTTP/HTTPS GET requests by default. To use this feature,
you need to specify the trusted IP address(es) for action URI in advance. For more information,
refer to Configuring Trusted IP Address for Action URI on page 698.
Procedure
Reboot in talking can be configured using the following methods.
Central Provisioning
(Configuration File)
<y0000000000xx>.c
fg
Configure reboot in talking.
Parameter:
features.reboot_in_talk_enable
Web User Interface
Configure reboot in talking.
Navigate to:
http://<phoneIPAddress>/servlet?p=feature
s-general&q=load
Details of Configuration Parameter:
Parameter
Permitted Values
Default
features.reboot_in_talk_enable
0 or 1
0
Description:
Enables or disables the phone to reboot during a call when it receives a reboot request by
action URI.
0-Disabled
1-Enabled
Note: It works only if the value of the parameter “features.action_uri_limit_ip” is set to “any”
or trusted IP address(es) and it is not the first time for the IP phone to receive HTTP/HTTPS
GET request from the trusted IP address(es).
Web User Interface:
Features->General Information->Reboot in Talking
Phone User Interface:
None
To configure reboot in talking via web user interface:
1. Click on Features->General Information.

Yealink SIP-T2 Series Specifications

General

Brand	Yealink
Model	SIP-T2 Series
Category	IP Phone
Language	English