Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
360
To configure auto redial via phone user interface:
1. Press Menu->Features->Others->Auto Redial.
2. Press or , or the Switch soft key to select the desired value from the Auto Redial
field.
3. Enter the waiting time (in seconds) in the Redial Interval field.
4. Enter the desired times in the Redial Times field.
5. Press the Save soft key to accept the change.
Auto Answer
Auto answer allows IP phones to automatically answer an incoming call. By default, the IP
phones will not automatically answer the incoming call during a call or while dialing even if auto
answer is enabled; and the incoming call will not be automatically answered if you end the current
call or cancel the dialing. You can configure the IP phones to automatically answer the incoming
call after ending all calls or canceling the dialing. Auto answer is configurable on a per-line basis.
Auto-Answer delay defines a period of delay time before the IP phone automatically answers
incoming calls.
Auto Answer Tone
Auto answer tone allows the IP phones to play a tone when an incoming call is automatically
answered. You can customize the auto answer tone or select specialized tone sets (vary from
country to country) for your IP phone. For more information, refer to Tones on page 784.
Auto Answer Mute
Auto answer mute allows IP phones to mute the local microphone when an incoming call is
automatically answered.
Procedure
Auto answer can be configured using the following methods.
Central
Provisioning
(Configuration
File)
Configure auto answer and auto answer
mute for SIP account X.
Parameter:
account.X.auto_answer
Specify a period of delay time for auto
answer.
Parameter:
features.auto_answer_delay
To Next Page
Loading...
Need help?
General
