Yealink SIP-T2 Series User Manual

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
578
Parameters
Permitted Values
Default
status.
Note: It is not applicable to SIP-T19(P) E2 IP phones. For the Genband server, you can set
the value of this parameter to 4.
Web User Interface:
Features->General Information->BLF LED Mode
Phone User Interface:
None
To configure BLF LED mode via web user interface:
1. Click on Features->General Information.
2. Select the desired value from the pull-down list of BLF LED Mode.
3. Click Confirm to accept the change.
You can customize the BLF LED status and BLF key behavior using the EDK macros if required.
For more information on EDK macros, refer to Understanding Macro Action Strings on page 744.
The following behaviors are supported when pressing the BLF/BLF List keys:
 newcall - dial out the phone number
 btransfer - transfer the active call to the monitored user without consulting
 ctransfer - transfer the active call to the monitored user with prior consulting
 pickup - pick up the call directly

Yealink SIP-T2 Series Specifications

General

Brand	Yealink
Model	SIP-T2 Series
Category	IP Phone
Language	English