Yealink SIP-T2 Series

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
450
Allow Trans Exist Call
Allow trans exist call feature allows users to select transfer-to party’s call during multiple calls. It
is convenient to transfer the active call to another existing call. It is not applicable to
SIP-T48G/T48S/T46G/T46S/T29G IP phones.
For example, party A (1001) has two calls on line 1, one with party B (1011) and the other with
party C (1012). If party A transfers the call with party B by pressing the Tran soft key, a “Transfer
to” screen will display on the phone. In this case, party A can select to transfer the call to a new
number or party C (1012).
Procedure
Allow trans exist call can be configured using the following methods.
Central Provisioning
(Configuration File)
<y0000000000xx>.
cfg
Configure allow trans exist call.
Parameter:
transfer.multi_call_trans_enable
Web User Interface
Configure allow trans exist call.
Navigate to:
http://<phoneIPAddress>/servlet?p=fea
tures-general&q=load
Details of Configuration Parameter:
Parameter
Permitted Values
Default
transfer.multi_call_trans_enable
0 or 1
1
Description:
Enables or disables the IP phone to select transfer-to party's call (a new call or another
existing call) during multiple calls when user presses the Tran/Transfer soft key or
TRAN/TRANSFER key.
0-Disabled
1-Enabled
If it is set to 1 (Enabled), the user can select to transfer the active call to a new call or another
existing call during multiple calls when the user presses the Tran/Transfer soft key or