Yealink SIP-T2 Series

Configuring Basic Features
449
Parameter:
transfer.dsskey_deal_type
Web User Interface
Configure the transfer mode via
dsskey.
Navigate to:
http://<phoneIPAddress>/servlet?p
=features-transfer&q=load
Details of the Configuration Parameter:
Parameter
Permitted Values
Default
transfer.dsskey_deal_type
0, 1 or 2
2
Description:
Configures the transfer mode when user presses the DSS key during an active call.
0-New Call
1-Attended Transfer
2-Blind Transfer
Note: To use this feature, you need to configure the DSS key as a speed dial, transfer or
BLF/BLF List in advance. It is not applicable to SIP-T19(P) E2 IP phones.
Web User Interface:
Features->Transfer->Transfer Mode via Dsskey
Phone User Interface:
None
To configure transfer mode via dsskey via web user interface:
1. Click on Features->Transfer.
2. Select the desired value from the pull-down list of Transfer Mode via Dsskey.
3. Click Confirm to accept the change.