Yealink SIP-T2 Series User Manual

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
448
To configure feature key synchronization via web user interface:
1. Click on Features->General Information.
2. Select Enabled from the pull-down list of Feature Key Synchronization.
3. Click Confirm to accept the change.
Transfer Mode via Dsskey
Transfer mode via dsskey enables IP phones to handle the current call differently via the DSS key.
IP phones support three transfer modes: New Call, Blind Transfer and Attended Transfer. For
more information on Blind Transfer and Attended Transfer, refer to Call Transfer on page 439.
Note
The transfer mode via dsskey feature is available when the DSS key is assigned to the following
features:
 Speed dial
 Transfer
 BLF/BLF List
For more information on how to configure the DSS Key, refer to Appendix D: Configuring DSS
Key on page 948.
Procedure
Transfer mode via dsskey can be configured using the following methods.
Central Provisioning
(Configuration File)
<y0000000000xx>.cfg
Configure the transfer mode via
dsskey.
It is not applicable to SIP-T19(P) E2 IP phones.

Yealink SIP-T2 Series Specifications

General

Brand	Yealink
Model	SIP-T2 Series
Category	IP Phone
Language	English