Yealink SIP-T2 Series

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
590
Parameters
Permitted Values
Default
Description:
Configures the behavior when pressing the BLF/BLF list key if the monitor is talking and a
call is being parked against the monitored phone.
Example:
blf.enhanced.parked.talking.action = newcall
Note: It is not applicable to SIP-T19(P) E2 IP phones. It works only if the value of the
parameter “blf.enhanced.parked.enable” is set to 1 (Enabled).
Web User Interface:
None
Phone User Interface:
None
You can configure a BLF key on a supervisor’s phone to monitor the IP phone user status (busy
or idle). For more information on how to configure the DSS Key, refer to Appendix D:
Configuring DSS Key on page 948.
Procedure
BLF key can be configured using the following methods.
Central
Provisioning
(Configuration
File)
<y0000000000xx>.c
fg
Assign a BLF key.
Parameters:
linekey.X.type/
expansion_module.X.key.Y.type
linekey.X.line/
expansion_module.X.key.Y.line
linekey.X.value/
expansion_module.X.key.Y.value
linekey.X.pickup_value/
expansion_module.X.key.Y.pickup_value
linekey.X.label/
expansion_module.X.key.Y.label
Web User Interface
Assign a BLF key.
Navigate to:
http://<phoneIPAddress>/servlet?p=dsskey