Yealink SIP-T2 Series

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
262
Specify the access URL of the
custom logo file.
Parameter:
lcd_logo.url
Delete all custom logo files.
Parameter:
lcd_logo.delete
Web User Interface
Configure the logo shown on the
idle screen.
Upload the custom logo file.
Navigate to:
http://<phoneIPAddress>/servlet?p
=features-general&q=load
Details of Configuration Parameters:
Parameters
Permitted Values
Default
phone_setting.lcd_logo.mode
0, 1 or 2
0
Description:
Configures the logo mode of the LCD screen.
0-Off
1-System logo
2-Custom logo
If it is set to 0 (Off), the IP phone is not allowed to display a logo.
If it is set to 1 (System logo), the LCD screen will display the system logo.
If it is set to 2 (Custom logo), the LCD screen will display the custom logo (you need to
upload a custom logo file to the IP phone).
Note: It is not applicable to SIP-T48G/T48S/T46G/T46S/T29G IP phones.
Web User Interface:
Features->General Information->Use Logo
Phone User Interface:
None
lcd_logo.url
URL within 511
characters
Blank
Description:
Configures the access URL of the custom logo file.