Yealink SIP-T2 Series

Configuring Basic Features
355
Procedure
Call waiting and call waiting tone can be configured using the following methods.
Central Provisioning
(Configuration File)
<y0000000000xx>.cfg
Configure call waiting and call
waiting tone.
Parameters:
call_waiting.enable
call_waiting.tone
call_waiting.on_code
call_waiting.off_code
Web User Interface
Configure call waiting.
Navigate to:
http://<phoneIPAddress>/servlet?p
=features-general&q=load
Configure call waiting tone.
Navigate to:
http://<phoneIPAddress>/servlet?p
=features-audio&q=load
Phone User Interface
Configure call waiting and call
waiting tone.
Details of Configuration Parameters:
Parameters
Permitted Values
Default
call_waiting.enable
0 or 1
1
Description:
Enables or disables call waiting feature.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), a new incoming call is automatically rejected by the IP phone with a
busy signal (configured by the parameter “features.normal_refuse_code”) while during a call.
If it is set to 1 (Enabled), the LCD screen will present a new incoming call while during a call.
In both cases, users can put an active call on hold to make outgoing calls.
Web User Interface:
Features->General Information->Call Waiting
Phone User Interface: