Yealink SIP-T2 Series

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
366
http://<phoneIPAddress>/servlet?p
=features-general&q=load
Details of Configuration Parameter:
Parameter
Permitted Values
Default
features.ip_call.auto_answer.enable
0 or 1
0
Description:
Enables or disables the auto answer feature for IP call.
0-Disabled
1-Enabled
If it is set to 1 (Enabled), the IP phone can automatically answer an IP call.
Note: It works only if the value of the parameter “features.direct_ip_call_enable” is set to 1
(Enabled). The IP phone cannot automatically answer the incoming IP call during a call even
if IP call auto answer is enabled.
Web User Interface:
Feature->General Information->IP Direct Auto Answer
Phone User Interface:
None
To configure IP direct auto answer via web user interface:
1. Click on Features->General Information.
2. Select the desired value from the pull-down list of IP Direct Auto Answer.
3. Click Confirm to accept the change.