Yealink SIP-T2 Series

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
378
The anonymous call rejection on code and anonymous call rejection off code configured on IP
phones are used to activate/deactivate the server-side anonymous call rejection feature. They
may vary on different servers. Send Anonymous Rejection Code feature allows IP phones to
send anonymous call rejection on/off code to the server.
Procedure
Anonymous call rejection can be configured using the following methods.
Central
Provisioning
(Configuration
File)
<MAC>.cfg
Configure anonymous call rejection.
Parameters:
account.X.reject_anonymous_call
account.X.send_anonymous_rejection_code
account.X.anonymous_reject_oncode
account.X.anonymous_reject_offcode
Web User Interface
Configure anonymous call rejection.
Navigate to:
http://<phoneIPAddress>/servlet?p=account
-basic&q=load&acc=0
Phone User Interface
Configure anonymous call rejection.
Details of Configuration Parameters:
Parameters
Permitted Values
Default
account.X.reject_anonymous_call
0 or 1
0
Description:
Triggers the anonymous call rejection feature to on or off for account X.
0-Off
1-On
If it is set to 1 (On), the IP phone will automatically reject incoming calls from users enabled
anonymous call feature. The anonymous user’s phone LCD screen presents “Anonymity
Disallowed”.
X ranges from 1 to 16 (for SIP-T48G/T48S/T46G/T46S/T29G)
X ranges from 1 to 12 (for SIP-T42G/T42S)
X ranges from 1 to 6 (for SIP-T41P/T41S/T27P/T27G)
X ranges from 1 to 3 (for SIP-T40P/T40G/T23P/T23G)
X ranges from 1 to 2 (for SIP-T21(P) E2)
X is equal to 1 (for SIP-T19(P) E2)
Web User Interface: