Yealink SIP-T2 Series

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
444
Parameters
Permitted Values
Default
X ranges from 1 to 6 (for SIP-T41P/T41S/T27P/T27G)
X ranges from 1 to 3 (for SIP-T40P/T40G/T23P/T23G)
X ranges from 1 to 2 (for SIP-T21(P) E2)
X is equal to 1 (for SIP-T19(P) E2)
Web User Interface:
Account->Advanced->Conference Type
Phone User Interface:
None
account.X.conf_uri
SIP URI within
511 characters
Blank
Description:
Configures the network conference URI for account X.
X ranges from 1 to 16 (for SIP-T48G/T48S/T46G/T46S/T29G)
X ranges from 1 to 12 (for SIP-T42G/T42S)
X ranges from 1 to 6 (for SIP-T41P/T41S/T27P/T27G)
X ranges from 1 to 3 (for SIP-T40P/T40G/T23P/T23G)
X ranges from 1 to 2 (for SIP-T21(P) E2)
X is equal to 1 (for SIP-T19(P) E2)
Example:
account.1.conf_uri = conference@example.com
Note: It works only if the value of the parameter “account.X.conf_type” is set to 2 (Network
Conference).
Web User Interface:
Account->Advanced->Conference URI
Phone User Interface:
None
To configure the network conference via web user interface:
1. Click on Account->Advanced.
2. Select the desired account from the pull-down list of Account.
3. Select Network Conference from the pull-down list of Conference Type.