Yealink SIP-T2 Series

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
526
Procedure
SIP send MAC can be configured using the following methods.
Central Provisioning
(Configuration File)
<MAC>.cfg
Configure SIP send MAC on a
per-line basis.
Parameter:
account.X.register_mac
Web User Interface
Configure SIP send MAC on a
per-line basis.
Navigate to:
http://<phoneIPAddress>/servlet?p
=account-adv&q=load&acc=0
Details of the Configuration Parameter:
Parameter
Permitted Values
Default
account.X.register_mac
0 or 1
0
Description:
Enables or disables the IP phone to add MAC address to the SIP header of the REGISTER
message for account X.
0-Disabled
1-Enabled
X ranges from 1 to 16 (for SIP-T48G/T48S/T46G/T46S/T29G)
X ranges from 1 to 12 (for SIP-T42G/T42S)
X ranges from 1 to 6 (for SIP-T41P/T41S/T27P/T27G)
X ranges from 1 to 3 (for SIP-T40P/T40G/T23P/T23G)
X ranges from 1 to 2 (for SIP-T21(P) E2)
X is equal to 1 (for SIP-T19(P) E2)
Web User Interface:
Account->Advanced->SIP Send MAC
Phone User Interface:
None
To configure SIP send MAC feature via web user interface:
1. Click on Account->Advanced.
2. Select the desired account from the pull-down list of Account.