Yealink SIP-T2 Series - Page 720

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
696
Variable Value
Phone Action
CALLEND
End a call.
phonecfg=get[&accounts=x][&dnd=x
][&fw=x]
Get firmware version, registration, DND or
forward configuration information.
The valid value of “x” is 0 or 1, 0 means you do
not need to get configuration information. 1
means you want to get configuration
information.
Note: The valid URI is:
http(s)://<phoneIPAddress>/servlet?phonecfg
=get[&accounts=x][&dnd=x][&fw=x]
Example:
http://10.3.20.10/servlet?phonecfg=get[&acco
unts=1][&dnd=0][&fw=1]
CallWaitingOn
Activate the call waiting feature.
CallWaitingOff
Deactivate the call waiting feature.
AlwaysFwdOn/BusyFwdOn/NoAnswF
wdOn=xxx=n
Activate an always/busy/no answer forward
feature to xxx for the IP phone (“xxx” means the
destination number)
The valid value of “n” means the duration time
(seconds) before forwarding incoming calls (n
is the times of 6, e.g., 24). It is only applicable to
no answer forward feature.
Note: It works only if the value of the
parameter “features.fwd.allow” is set to 1
(Enabled) and call forward mode is Phone, the
always/busy/no answer forward feature will
apply to all the accounts on the phone.
Example:
http://10.10.20.10/servlet?key=NoAnswFwdOn
=1001=24