Yealink SIP-T2 Series - Page 723

Configuring Advanced Features
699
sending the action URI to the IP
phone.
Navigate to:
http://<phoneIPAddress>/servlet?p=f
eatures-remotecontrl&q=load
Details of the Configuration Parameters:
Parameters
Permitted Values
Default
features.action_uri.enable
0 or 1
1
Description:
Enables or disables the IP phone to receive the action URI requests.
0-Disabled
1-Enabled
Web User Interface:
None
Phone User Interface:
None
features.show_action_uri_option
0 or 1
1
Description:
Enables or disables the phone to pop up the Allow Remote Control prompt.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), the phone will not pop up the Allow Remote Control prompt
when receiving an HTTP or HTTPS GET request, or receiving a SIP NOTIFY message with the
“Event: ACTION-URI” header. The phone will directly perform the specified action.
Note: It works only if the value of the parameter “features.action_uri.enable” is set to 1
(Enabled).
Web User Interface:
None
Phone User Interface:
None
features.action_uri_limit_ip
IP address or any
Blank
Description: