Yealink SIP-T2 Series

Configuring Audio Features
797
Procedure
Headset prior can be configured using the following methods.
Central Provisioning
(Configuration File)
<y0000000000xx>.cfg
Configure headset prior.
Parameter:
features.headset_prior
Web User Interface
Configure headset prior.
Navigate to:
http://<phoneIPAddress>/servl
et?p=features-general&q=load
Details of the Configuration Parameter:
Parameter
Permitted Values
Default
features.headset_prior
0 or 1
0
Description:
Enables or disables headset prior feature. You need to press the HEADSET key to activate
the headset mode in advance.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), the headset mode can be deactivated by pressing the
Speakerphone key or the HEADSET key except off-hook.
If it is set to 1 (Enabled), the headset mode will not be deactivated until the user presses the
HEADSET key again.
Note: It works only if the value of the parameter “features.headset_mode.enable” is set to 1
(Enabled).
Web User Interface:
Features->General Information->Headset Prior
Phone User Interface:
None
To configure headset prior via web user interface:
1. Click on Features->General Information.