17-4
IM WT18
O
1E-02EN
Setting Auto Naming (Auto Naming)
OFF: The auto naming feature is not used. The name that you specified for the File Name
setting is used. If there is a file with the same name in the save destination folder, you
cannot save the data.
Numbering: This instrument automatically adds a four-digit number from 0000 to 0999 after the
common name that you specified for the File Name setting and saves the file.
Date: The file name is the date and time (down to seconds) when the file is saved. The file
name that you specified for the File Name setting is ignored.
Y
M
D
H
Min
S
20100930_121530_0 (2010/09/30 12:15:30)
The sequence number (0-9, A-Z) that is appended
if a file name with the exact same date and time
(down to seconds) exists.
The sequence number that comes after the date and time is appended if a file name
with the exact same date and time (down to seconds) exists. The sequence number is
incremented by one (0 to 9 and then A to Z) each time a file is added.
Setting the File Name (File Name)
You can set the file name that is used when Auto Naming is set to OFF. This is also used as the
common file name when Auto Naming is set to Numbering. The maximum number of characters that
you can use for file names and folder names is 32 characters. However, there are limitations on the
type of characters and the character strings that you can use.
Setting the Comment (Comment)
You can add a comment that consists of up to 30 characters when saving files. You do not have to
enter a comment. All characters, including spaces, can be used in comments.
17.2 Saving Setup Parameters
To Next Page
Loading...
