14-3
IM WT18
O
1E-02EN
14.3 Performing Cursor Measurements on Bar
Graphs
This section explains the following settings for performing cursor measurements on bar graphs:
• Turning the cursor display on and off
• Cursor position
• Turning linked cursor movement on and off
► “Cursor Measurement” in the features guide
1.
Follow the procedures in chapter 11 to display bar graphs.
Bar Cursor Menu
2.
Press SHIFT+FORM (CURSOR) to display the following menu.
Turns the cursor display on and off
Set the harmonic order of the bar graph to measure with cursor 1 (+) and cursor 2 (×)
(0 to 500).
Turns linked cursor movement on and off
To Next Page
Loading...
