5-1
IM WT18
O
1E-02EN
5.1 Holding Measured Values
This section explains how to hold measured values.
► “Holding Measured Values (HOLD)” in the features guide
Press HOLD. The HOLD key illuminates, and the displayed measured value is held.
• Values such as D/A output, the list of numeric data that is being printed on the built-in printer, and
communication output are also held.
• Press HOLD again to turn the HOLD key off. This releases the hold feature. The measured data is then
updated at the specified data update rate (see section 1.15).
Data update interval
If you hold the measured value, the data update count in the lower
left of the screen stops increasing.
Chapter 5 Holding Measured Values and Performing Single Measurements
To Next Page
Loading...
