21-5
IM WT18
O
1E-02EN
21.5 Configuring the Environment Settings
This section explains the following environment settings:
• Number of digits of numeric data to display
• Frequency display value when the measured frequency is less than the lower limit
• Motor display value (/MTR option) when the measured pulse frequency is less than the lower limit
• Decimal point and separator to use when data is saved in ASCII format (.CSV)
• Integration resume action at power failure recovery
• Menu font size
• Rounding to zero
► “Environment Settings (Preference)” in the features guide
Preference Menu
Press UTILITY, the System Config soft key, and then the Preference soft key to display the following
menu.
On models with the /MTR option, set the motor display value when the measured pulse
frequency is less than the lower limit (0, Error).
Set the decimal point and separator to use when data is saved in ASCII format as a .CSV
file (Period, Comma).
Set the menu font size (Small, Large).
Set the number of digits of numeric data to display (4digits, 5digits).
Set the frequency display value when the measured frequency is less than the lower
limit (0, Error).
Set the integration resume action at power failure recovery (Start, Stop, Error).
Turns rounding to zero on and off
To Next Page
Loading...
Need help?
General
