YOKOGAWA WT1801E - Chapter 9 Waveform Display; Setting the Display Format

9-1
IM WT18 O 1E-02EN
Chapter 9 Waveform Display
9.1 Setting the Display Format
This section explains the following settings for the waveform display format:
• Number of divisions of the waveform screen
• Time axis
• Trigger
• Advanced waveform display settings
• Waveform mapping
► “Display Format (FORM)—Waveform” in the features guide
Wave Form Menu
Press WAVE and then FORM to display the following menu.
If the setup parameter list is being displayed (the INPUT INFO key is illuminated), the Info Form menu may
be displayed. If this happens, press FORM again.
Set the number of divisions of the waveform screen (Single, Dual, Triad, Quad, Hexa).
1
Set waveform mapping.
Set the time axis (0.05 ms to ).
2
Configure trigger settings.
3
Configure the advanced waveform display settings.
the specified data update interval
10
1 In addition to using this Format soft key, you can repeatedly press WAVE to
change the order and the number of divisions.
2 For information on how to set the data update interval, see section 1.15.
3 You can set this when the data update interval is not Auto.
Configuring Trigger Settings (Trigger Settings)
Press the Trigger Settings soft key to display the following menu.
Set the trigger slope ( , , ).
Set the trigger mode (Auto, Normal, OFF).
Set the trigger source (U1, I1, U2, I2, U3, I3, U4, I4, U5, I5, U6, I6, Ext Clk).
Set the trigger level (0.0% to ±100.0%).