YOKOGAWA WT1801E - Chapter 14 Cursor Measurements; Performing Cursor Measurements on Waveforms

14-1
IM WT18 O 1E-02EN
Chapter 14 Cursor Measurements
14.1 Performing Cursor Measurements on
Waveforms
This section explains the following settings for performing cursor measurements on waveforms:
• Turning the cursor display on and off
• The waveforms to perform cursor measurements on
• Cursor movement path
• Cursor position
• Turning linked cursor movement on and off
► “Cursor Measurement” in the features guide
1.
Follow the procedures in chapter 9 to display waveforms.
Wave Cursor Menu
2.
Press SHIFT+FORM (CURSOR) to display the following menu.
Set the cursor movement path (Max, Min, Mid).
Turns the cursor display on and off
Set the waveform to measure with cursor 1 (+) (U1, I1, U2, I2, U3, I3, U4, I4, U5, I5, U6, I6,
Speed,
1
Torque,
1
Aux1,
2
Aux2
2
).
Set the waveform to measure with cursor 2 (×) (U1, I1, U2, I2, U3, I3, U4, I4, U5, I5, U6, I6,
Speed,
1
Torque,
1
Aux1,
2
Aux2
2
).
Set the positions of cursor 1 (+) and cursor 2 (×) (0, which is the left edge of the screen
to 800, which is the right edge of the screen)
Turns linked cursor movement on and off
1 This feature is available on models with the /MTR option.
2 This feature is available on models with the /AUX option.