YOKOGAWA WT1801E - Performing Single Measurements

5-2
IM WT18 O 1E-02EN
5.2 Performing Single Measurements
This section explains how to perform single measurements.
► “Single Measurement (SINGLE)” in the features guide
1.
Press HOLD. The HOLD key illuminates, and the displayed measured value is held.
2.
Press SINGLE. A single measurement is performed at the specified data update rate, and this
instrument then holds the measured value.
Note
• If, while the HOLD key is illuminated, you press HOLD again, the HOLD key will turn off, and the hold
feature will be released.If you press SINGLE while the hold feature is released, the measured value is
updated (re-measured) when the time specified by the data update rate elapses after you press the key.
• When the data update interval is set to Auto, single measurement is not possible.