8-5
IM WT18
O
1E-02EN
8.3 Starting, Stopping, and Resetting Integration
This section explains how to start, stop, and reset integration.
► “Starting, Stopping, and Resetting Integration (Start/Stop/Reset)” in the features guide
Integ Menu
Press INTEG to display the following menu.
Starts integration
This instrument starts integration using the integration mode that you have specified (see
section 8.2).
• The START indicator to the right of the INTEG key illuminates.
Integration has started; “Integ: Start” is displayed.
*
• The START indicator to the right of the INTEG key blinks.
The integration operation is ready; “Integ: Ready” is displayed.
*
Stops integration
This instrument automatically stops integration according to the integration mode that you have
specified. To force integration to stop, press this soft key. The integration time and integrated
value are held.
• The STOP indicator to the right of the INTEG key blinks.
Integration has stopped; “Integ: Stop” is displayed.
*
If you press the Start soft key when “Stop” is displayed in yellow, you can resume integration
from the point where you stopped integration.
• The STOP indicator to the right of the INTEG key illuminates.
Integration has stopped automatically because the integration timer has expired; “Integ:
TimeUp” is displayed.
*
Integration has stopped automatically because of real-time control; “Integ: Stop” is
displayed.
*
“Stop” is displayed in orange.
Resets the integration time and integrated value.
All integration data is deleted, and the no-data display, “-------,” appears.
The STOP indicator to the right of the INTEG key turns off.
* Character strings are displayed in the upper-right section of the screen.
Note
If you do not reset integration, you will not be able to start it again.
To Next Page
Loading...
Need help?
General
