YOKOGAWA WT1801E - Page 127

20-2
IM WT18 O 1E-02EN
20.1 Connecting this instrument to a Network
Connection Procedure
To Connect to a PC over a Network
1.
Turn off this instrument.
2.
Connect one end of a UTP (or STP) cable to the ETHERNET 1000BASE-T port on the rear
panel.
3.
Connect the other end of the UTP (or STP) cable to a hub or router.
4.
Turn on this instrument.
Hub or router that supports 1000BASE-T
UTP or STP cable
(straight cable)
PC
WT
To Connect to a PC through a Hub or Router
1.
Turn off this instrument and the PC.
2.
Connect one end of a UTP (or STP) cable to the ETHERNET 1000BASE-T port on the rear
panel.
3.
Connect the other end of the UTP (or STP) cable to a hub or router.
4.
Connect the PC to the hub or router in the same way.
5.
Turn on this instrument.
Hub or router that supports 1000BASE-T
UTP or STP cable
(straight cable)
PC
WT
Note
• Use a hub or router that supports the data rate of your network.
• When you connect a PC to this instrument through a hub or router, the PC must be equipped with an auto
switching 1000BASE-T/100BASE-TX/10BASE-T network card.
• Do not connect this instrument to a PC directly. Direct communication without a hub or router is not
guaranteed to work.