15-10
IM WT18
O
1E-02EN
1.
Follow the procedure in section 15.1 to select High Speed Data Capturing on the Others menu.
HS Settings Menu
2. Press FORM to display the following menu.
Starts high speed data capturing
High speed data capturing starts according to the specified number of data captures (see
section 15.1), the capture control settings (see section 15.1), and the save conditions (see
section 15.2).
• When high speed data capturing is started, “HS State: Start” appears in the upper right
of the screen.
• When the captured data is being saved, “File State: Rec” appears in the upper left of
the screen.
Stops high speed data capturing
After the specified number of data captures have been made, high speed data capturing
automatically stops. To force high speed data capturing to stop, press this soft key.
When high speed data is stopped, “HS State: Ready” appears in the upper right of the
Note
• You cannot restart high speed data capturing without first stopping high speed data capturing.
• After you stop high speed data capturing and then change the settings or restart high speed data
capturing, the data captured up to that point is deleted.
15.4 Starting and Stopping High Speed Data Capturing
To Next Page
Loading...
