13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 4-29
Maintenance Section 4
Install the Rewind Drive Belt
1. Install the replacement rewind drive belt onto the inner stepper motor pulley, inside
the idler pulley, around the lower peel roller pulley, and slide it onto the rewind
spindle pulley.
2. Refer to RRP No. 7 on page 4-26 and adjust the tension on the rewind drive belt.
3. Reinstall the power supply.
4. Refer to RRP No. 6 on page 4-25 and reinstall the main drive belt.
5. Refer to RRP No. 5 on page 4-23. Adjust the tension on the main drive belt and
place the printer back into service.
6. Reinstall the electronics cover.
7. Reinstall the media and ribbon.
8. Reinstall the AC power cord and data cables.
9. Turn the printer On (l).
Remove and Install the Printhead
Remove the Printhead
Refer to Figure 15 while performing the following procedure.
1. Turn the printer Off (O), remove the AC power cord and data cables.
2. Open the printhead assembly and remove the media and ribbon; then close the
printhead assembly.
3. Loosen the spring-loaded mounting screw until it disengages from the printhead.
4. Slowly open the printhead assembly. The printhead remains on the platen while the
rest of the assembly pivots back out of the way.
5. Spread apart the holding tabs on the sides of the printhead data connector to release
the data cable.
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer
from the power source before performing the following maintenance.
Caution:
The printer electronics are susceptible to static discharge. Before proceeding, it
is highly recommended that the technician wear an antistatic wrist strap
connected to the printer chassis.
Caution:
Printhead may be hot and can cause burns if touched. Exercise care when
handling.
To Next Page
Loading...
Need help?
General
