13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 4-49
Maintenance Section 4
Adjust the Roller Plate
The lower roller alignment has the same effect on media tracking as the rewind plate
alignment does in Rewind Mode.
Figure 4-28. Peel-Off Lower Roller Alignment
1. Refer to Figure 4-24. Loosen the two screws that attach the platen support bracket to
the side plate.
2. Adjust the bracket position as required and tighten the screws.
3. Run test labels and repeat the adjustment until the required results are achieved.
Lower Platen
Roller
Mounting
Screws
Platen Support
Bracket
Bearing
Bearing
Note • Moving the bracket toward the front of the machine moves the liner away
from the rewind tracking plate. Moving the bracket toward the rear of the
machine moves the liner toward the tracking plate.
To Next Page
Loading...