13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 4-39
Maintenance Section 4
Align the Take-Label (Label-Available) Sensor
The take-label sensor activates only when the printer is set to Peel-Off Mode. This mode
requires the Rewind or Peel option. The media take-label sensor pair is not installed on
printers without this option.
Refer to Figure 4-22 for the location of the take-label sensor components. When the beam
is broken, the printer is inhibited from printing or feeding in Peel-Off Mode only. It may,
however, accept additional label formats if the buffer is not full.
If you encounter problems, ensure the printer is set to Peel-Off Mode and the sensors are
aligned. Sensors are aligned at the factory or when the media rewind spindle option is
installed. Refer to your User Guide and do a manual calibration of the media and ribbon.
Figure 4-22. Take-Label Sensor Location
Take-Label
Sensors
To Next Page
Loading...