Zebra 110XiIII Plus Series User Manual

13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 4-1
Maintenance Section 4
Section 4
Maintenance
Maintenance Concepts
Maintenance for the Zebra 110XiIIIPlus thermal transfer demand printers can be divided
into two basic categories:
• Preventive Maintenance procedures and operator care instructions. These
procedures may be performed by the operator as well as the service technician and
should be performed on a regular basis. Preventive maintenance consists of a
visual inspection, general cleaning of the interior, exterior of the printer, and
cleaning the printhead and the associated media and ribbon paths.
• Corrective Maintenance provides the service technician detailed steps for
resolving faults by adjusting or replacing components or modules.
Table of Contents
Maintenance Concepts.......................................................................4-1
Safety Information .............................................................................4-5
Preventive Maintenance.....................................................................4-8
Clean the Zebra Printer ..........................................................4-8
Clean the Printhead....................................................4-10
Clean the Upper Media Guide (Snap Plate)...............4-11
Corrective Maintenance.....................................................................4-12
Tools Required for Corrective Maintenance .........................4-12
Test Equipment Required ......................................................4-12
Printer Parts and Locations ....................................................4-12
External Components.................................................4-12
Electrical Interconnections ........................................4-13
Routine Referral Procedures (RRP).......................................4-14
Remove Power and Disconnect Printer .....................4-14
Reconnect Printer.......................................................4-15
Remove Power Supply...............................................4-17
Install the Power Supply ............................................4-18
Remove the Main Logic Board..................................4-19
Install the Main Logic Board .....................................4-22
Adjust the Tension .....................................................4-23
Remove the Main Drive Belt .....................................4-25

Zebra 110XiIII Plus Series Specifications

General

Brand	Zebra
Model	110XiIII Plus Series
Category	Printer
Language	English