Page 4-2 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Section 4 Maintenance
Install Main Drive Belt ..............................................4-25
Remove the Rewind Drive Belt .................................4-28
Install the Rewind Drive Belt ....................................4-29
Remove and Install the Printhead ..........................................4-29
Remove the Printhead................................................4-29
Install the Printhead ...................................................4-30
Adjust Printhead ....................................................................4-32
Toggle Pressure..........................................................4-33
Printhead Position ......................................................4-34
Adjust the Wear Plate (Balance) Position..............................4-36
Test Printhead Parallelism .....................................................4-37
Adjust Printhead Parallelism .....................................4-37
Adjust the Strip Plate .............................................................4-38
Adjust Darkness.....................................................................4-38
Align the Take-Label (Label-Available) Sensor ...................4-39
Adjust the Media Tracking ....................................................4-40
Rewind Mode.............................................................4-40
Peel-Off Mode ...........................................................4-41
Adjust and Maintain Spindle .................................................4-42
Tension Measurement Procedure...............................4-43
Adjust the Spindle Tension........................................4-43
Spindle Maintenance..................................................4-43
Replace the Platen Roller.......................................................4-44
Remove the Upper Platen Roller ...............................4-44
Install the Upper Platen Roller...................................4-45
Remove and Install the Rewind (Lower) Platen Roller.........4-46
Remove the Rewind Platen Roller.............................4-46
Install the Rewind Platen Roller ................................4-48
Adjust the Roller Plate...............................................4-49
Replace the Platen Pulley ......................................................4-50
Remove and Install the Upper Platen Pulley .............4-50
Remove and Install the Lower Platen Pulley.............4-51
Replace the Cutter Components ............................................4-54
Remove and Install the Cutter Main Link .................4-54
Remove and Install the Cutter Slotted Link...............4-56
Remove and Install the Cutter PCB...........................4-57
Align the Lower Drive Arm.......................................4-59
To Next Page
Loading...
Need help?
General
